First remove
the 3 closest clips holding the black plastic cover in front
of the rad. Gently slid your side cutters under the head of
the plastic rivet pin and lift it up. You don't need to remove
it completely. |
 |
| Then lift the
cover away from the light so that you can access the back of
the light. Their isn't much room, but enough to get the light
out easily. |
Click image for a closer look
|
| Now get a large
screwdriver behind the light assembly and give it a good push
forward. It should just pop out. |
Click image for a closer look
|
| Here is what the
lamp assembly looks like. Just push the release on the bulb
holder and twist to release it from the lamp assembly. The
bulb may push in and twist to remove, or it may just pull
straight out like this one.
Reassembly is the reverse of removing
the assembly. Line up the pins in the sockets and give it a
firm push. Replace the plastic cover and push the retaining
rivets back in. |
Click image for a closer look
|
